Metal Heatsink Case for Raspberry Pi 4 Board
This metal heatsink case is specially designed for cooling down your Raspberry Pi 4B!
Made of aluminum alloy, the case can protect your mainboard from all directions and provide a good heat dissipation effect. Inside the case, there is a silicon heat sink closely attached to the Raspberry Pi chip and radiator, by which the heat generated from Pi board can be transferred to the radiator, and then be blown out through the fan. With a complete heat dissipation process from inside to outside, this product can bring double cooling effects and ultimate cooling experience for your Pi mainboard.
Aluminum alloy material is more conducive to shell heat dissipation.
Accurate hole alignment
The hole position is precisely aligned, and the mainboard will not be damaged by disassembly.
Easy to assemble and disassemble, the upper and lower covers can be pulled
It can be replaced and installed at will without moving the main board, saving efficiency.
Efficient Heat Dissipation for Pi Chip
The shell is an independent radiator, and the fan supports efficient heat dissipation.
- Dimension: 92*64*40mm/3.62*2.52*1.57”
- Material: aluminum alloy
- Fan voltage: DC 5V
- Ethernet Ports
- 1 x Gigabyte ethernet ports
- USB-C Power Supply
- Stereo Audio Port
- HDMI connector
- Micro HDMI Ports
- USB Device Port
- 2 x USB 3.0 2 x USB 2.0
16 other products in the same category:
The Compute Module 4 IO Board is a companion board for Raspberry Pi Compute Module 4. It is designed for use both as a development system for Compute Module 4 and as an embedded board integrated into end products.
Deploy your outdoor Raspberry Pi project without concerning rain, snow, dust in this IP65 plastic case with clear top. This weatherproof enclosure has three IP67 SMA to u.FL(IPEX) cable connector for connectivity and a waterproof IP68 micro USB cable-end socket if you want to power your project with modified original Raspberry Pi power supply.
These spacers increase the internal height of our Modular Raspberry Pi Case by 10mm per spacer and can be stacked to increase the headroom further. Additional (longer) screws required - please read below notes.
This is a handy interface bridge between Mini PCIe 3G/4G/LTE modules and Raspberry Pi. You can easily insert a Mini PCIe module in this shield then start using high-speed cellular internet with your Raspberry Pi.
You also need to get a EC25 Mini PCle 4G/LTE Module and Antennas to make this product works.
Make your Pi a little slimmer with this microSD card adapter board. It slides in where the SD card goes but is half the length. Pop in a microSD card for a sleeker machine. The microSD card holder is a push-push type so you can push on the edge that sticks out to remove the card when necessary.
Enclosure designed for Raspberry-PI boards in rectangular version and consists of two identical halves that fit togather. It has windows on four sides for direct access to components. Well suited for users who frequently connect and disconnect from the PCB ports.
Flirc allows you to pair any remote control with your computer or media center (Including the Raspberry Pi!). Just walk through our super simple cross platform pairing application, and you're done. Use your previously paired remote with no additional software on any machine with Flirc.