ODROID-XU4 is a new generation of computing device with more powerful, more energy-efficient hardware and a smaller form factor. Offering open source support.
- Embedded Systems
- Ready Systems addremove
- IoT addremove
- VoIP addremove
- Wireless addremove
-
Components
add remove
- STEM Education
- Combo Kits
- Services
- Support
- Contact Us
3.5 Inch Touchscreen Shield
Reference: OD35TSSH
Fully assembled 3.5inch display with 480×320 pixels TFT LCD and a resistive touch overlay.
Fully assembled 3.5inch display with 480×320 pixels TFT LCD and a resistive touch overlay. Just plug it on top of ODROID-C2/C1+/C0.
ODROID-XU4 needs the Shifter-Shield board to use this display.
You will need an official Ubuntu image to configure it.
You can simply download the Kernel updates (via dist-upgrade) and configure your ODROID for this display shield.
Please follow the step by step guide from the WiKi. If not, the display doesn’t work.
Note: this display is NOT compatible with Android platform.
BOARD DETAIL
You can place the RTC Shield on the bottom side of the LCD Shield PCB. The RTC Shield must be purchased separately.
Data sheet
- Board Size
- 56(H) x 95(V) x 17(T)mm
- Controller
- ILI9488
- LCD
- Parallel 8-bit
- LCD Type
- TFT (480 x 320 pixels)
- Touch Screen
- Resistive
- Touch Screen Controller
- SX865X (I2C)
- Weight
- 54G
- Board Category
- ODROID-C0
ODROID-C1+
ODROID-C2
ODROID-N2+
ODROID-XU4

Fully assembled 3.5inch display with 480×320 pixels TFT LCD and a resistive touch overlay.
16 other products in the same category:
Blue illuminated Power Button with pre-assembled jumper wires.
This “Case Type 6” is designed for the user who needs high performance network with a minimal or regular range storages.
Discontinued
5pieces of 10pin male header is excellent choice for your DIY project.
A new and upgraded version of the USB-UART Module Kit featuring a USB-C Port.
The ODROID-GO Super (OGS) is an upgraded version of the very popular ODROID-GO Advance.
Lithium Polymer rechargeable cell with a protection circuit.
Fully assembled 3.2inch display with 320x240 pixels TFT LCD and a resistive touch overlay. Just plug it on top of ODROID-C1. 2x13 tall female header is already soldered on the PCB.
This board contains a USB3.0 to SATA3 controller (JMicron JMS578) allowing interfacing of a single 2.5" SATA HDD/SDD
RTC backup battery Lithium primary battery to back up the RTC on XU board. This battery can keep the RTC running up to 5 years without external power supply.
WIFI Module #5BK uses the same chipset (Realtek RTL8821CU) as WIFI Module #5B, so it is 100% compatible. IEEE 802.11ac/a/b/g/n WLAN and Bluetooth combo module with onboard 2.4Ghz and 5.8Ghz Dual band antenna.
Compact Stero Speaker for VU7A Plus and VU5A Plus