It is a good plastic box for Raspberry Pi, which can protect it with one of these snazzy plastic enclosures?. These cases protect the Raspberry Pi from things like rogue wires that might short it out while still allowing full access to the board! Simply snap the RPi into the bottom half of the enclosure, then snap the two sides together.
If you’re running multiple Raspberry Pis as a cluster, mining rig, server farm or any other project using multiple boards, our expandable Raspberry Pi cluster fan case is a great way to stack, display and cool your setup.
USB-C 24W Adapter, with USB-C power delivery. This new adapter is meant for use with Edge SBCs, as well as the new VIM3. Onboard controller negotiates the power supply needed by your SBC using the USB-C cable.
These spacers increase the internal height of our Modular Raspberry Pi Case by 10mm per spacer and can be stacked to increase the headroom further. Additional (longer) screws required - please read below notes.
The Raspberry Pi Case is designed to be fully customisable by the user, and adaptable to suit a range of requirements. The streamlined look and adaptability make it perfect for many applications.
This module is the 16 way GPIO expander for the I2C interface, and built with the MCP23017.MCP23017 has a high-speed I2C interface which supports the I2C frequency of 100KHz, 400KHz and 1.7MHz. The chip has 3 address pins, which can be set up for 8 different addresses. So 8 modules can be connected through two I2C buses to achieve up to 128 IO extensions.
A single native (non-USB) SATA 3.0 port on the ODROID-M1 is provided for use with a 2.5inch HDD or SSD NAND Memory storage device. This SATA interface delivers near 500MB/s of sequential access. The SATA mount kit contains a SATA Data cable, a SATA Power cable, and a mount plate with some support screws. However, since the SATA power port doesn’t have a...
It is a good plastic box for Raspberry Pi, which can protect it with one of these snazzy plastic enclosures?. These cases protect the Raspberry Pi from things like rogue wires that might short it out while still allowing full access to the board! Simply snap the RPi into the bottom half of the enclosure, then snap the two sides together.
