ODROID-H2 Case Type 3

This “Case Type 3” is designed for the user who needs high bandwidth network with mid-range storages. Basically, this is the fanless design and the heated air from a processor or the storages can be blow out through the 92mm cooling fan holes on top of this enclosure. But you also can install a 92x92mm standard PC cooling fan (optional) at the hole if the decent power for the fan is supplied.

Supported storages:

On-board eMMC 5.1 module

On-board M.2 NVMe (NGFF-2280)

• Up to 2 x 2.5” SATA HDD or SSD (Max height : 15mm)

• “SATA Data and Power Cable” must be purchased

• The disk drive mounting screws (M3x6mm) are included in the package.

• The power and reset switches are accessible through the hole at the front

• Optional power on/off switch (diameter 16mm) can be installed at the front

• 128 (L) x 157 (W) x 106 (H) mm

.
Package contents:

• A. Rear panel
• B. Left Panel
• C. Right panel
• D. 2.5” SATA HDD/SSD bracket
• E. 2.5” SATA HDD/SSD bracket
• F. Inner bracket
• G. Bottom panel
• H. Top panel
• I. Front panel
• J. 1 x 92mm Stainless Cooling Fan Grill
• K. 4 x 40mm (F) PCB Supports
• L. 4 x 40mm (M) PCB Supports
• M. 4 x 15mm (M) PCB Supports
• N. 4 x M5 Nuts
• O. 4 x M5 Truss Head Bolts
• P. 16 x 6mm M3 Truss Head Bolts
• Q. 4 x Rubber Feet (Round / Clear)

..
Optional accessory

• SATA Data and Power Cable
• LED Power Button
• 16Port I2C GPIO Board
• 92x92x25mm DC 5V Cooling Fan

.
Mechanical drawings

• https://dn.odroid.com/temp/box/ODROID-H2_TYPE3.dxf