This is a perfect connector pack for various DIY projects with the ODROID-C0. You need a soldering skill to use this pack.
Most of connectors are identical to the ODROID-C1+.
There are two different USB host connectors in this package.
If you want to make a lower profile board, use a single layer connector.
If you want to make a full connectivity, use a dual layer connector
.
B. Single Layer USB Type-A 4-Pin DIP Jack Connector
.
C. IR(InfraRed) Receiver Sensor
- This is a remote control receiver module that can accept standard 37.9Khz carrier frequency based wireless data.
D. UART Console Connector
- Molex 5268-04a(2.5mm pitch) is mounted on the PCB.
- Its mate is Molex 50-37-5043 Wire-to-Board Crimp Housing.
E. 7-pin Strip Male Header
- Add pins to the audio I2S interface holes in the ODROID-C0.
- 2.54mm(0.1inch) pitch
F. 20x2-pin Strip Male Header
- Add pins to the 40pin GPIO port.
- 2.54mm(0.1inch) pitch