This “Case Type 4” is designed for the user who needs high bandwidth network with mid-range storages. Basically, this is the fanless design and the heated air from a processor or the storages – especially a hard disk drive with a spinning motor – can be blow out through the two 92mm holes on top of the ODROID-H2 and the disk drives. But you also can install a 92x92mm standard PC cooling fan (optional) at a hole out of two on top of the ODROID-H2 if you supply the decent power for the fan.
Supported storages: Due to the physical limitation of the design, two different size of storages cannot be installed and below combination of the storage drives are supported.
On-board eMMC 5.1 module
On-board M.2 NVMe (NGFF-2280)
Up to 1 x 3.5” SATA HDD or SSD
Up to 2 x 2.5” SATA HDD or SSD (Max height : 15mm)
“SATA Data and Power Cable” must be purchased
The disk drive mounting screws (M3x6mm and #6-32x6mm) are included in the package.
The power and reset switches are accessible through the hole at the front
Optional power on/off switch (diameter 16mm) can be installed at the front
209 (L) x 132 (W) x 106 (H) mm
Package Contents:
A. Rear-top panel
B. Front panel
C. Rear-back panel
D. Rear panel
E. Front space filler
F. Bottom panel
G. 2.5”/3.5” inner drive bracket
H. Left panel
I. Right panel
J. Top panel
K. 1 x 92mm stainless cooling fan grill for front-top
L. 1 x 92mm stainless cooling fan grill for rear-top
This is a single LCD module as a spare part that we’ve put into the ODROID-GO kit. The display has 320×240 pixels and the communication interface is SPI.
PWM port on ODROID-U3 2pin header which connector is Molex 51021-0200 / 1.25mm pitch. The fan motor speed is controlled by CPU temperature proportionally
The ODROID-H3 has the same form factor & similar power efficiency as the previous version the ODROID-H2, But the ODORID-H3 is a way more powerful and offers higher performance rates.
VuShell is a laser cut acrylic enclosure for the ODROID-VU7Plus. You can make your own desktop PC with the fancy VuShell. VuShell allows for two different viewing angles.
The UPS2 for C1 is designed specifically for the ODROID-C1. Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut down the ODROID-C1
This “Case Type 1” is designed for the user who needs high bandwidth network with the high capacity storages for the high performance computing system.