Real Time Clock Shield for the ODROID-C2
- Embedded Systems
- Ready Systems addremove
- IoT addremove
- VoIP addremove
- Wireless addremove
-
Components
add remove
- STEM Education
- Combo Kits
- Services
- Support
- Contact Us
LED Power Button
Reference: ODLPB
Blue illuminated Power Button with pre-assembled jumper wires.
Blue illuminated Power Button with pre-assembled jumper wires.
Cable length : 260-290 mm
There is a small power switch on the ODROID-H2 board. But it is not easy to access the switch when you assemble(place?) the board in to a case. This beautifully illuminated power button is a good solution what you need!
This button can be mounted on the official acrylic case Type-1, Type-2, Type-3 and Type-4.
Note that the blue LED forward voltage must not exceed 3.5Volt.
Red wire: LED positive (Anode) : pin-4 or pin-7 or pin-14 on 20 pin header of ODROID-H2
Black wire: LED negative (Cathode) : GND(pin-1) on 20 pin header of ODROID-H2
Blue wire : Switch-A : #PWR_BTN(pin-17) in 20 pin header of ODROID-H2
Green wire : Switch-B: GND(pin-19) on 20 pin header of ODROID-H2

Blue illuminated Power Button with pre-assembled jumper wires.
16 other products in the same category:
"ODROID-GO Advance Black Edition" is a DIY Game kit just like the older version ODROID-GO.
Ideal for electronics projects, phone or tablets.
eMMC Version 5.1 interface or higher version from Samsung.
You're probably itching to make some fun embedded computer projects with ODROID-C2 or ODROID-C1+.
IEEE 802.11ac/a/b/g/n WLAN module with on-board 2.4Ghz and 5.8Ghz Dual band antenna.
CM108AH is a highly integrated single chip USB audio solution.
All essential analog modules are embedded in CM108AH, including dual DAC and headphone amplifier, ADC, microphone booster, PLL, regulator, and USB transceiver.
Fully assembled 3.5inch display with 480×320 pixels TFT LCD and a resistive touch overlay.
Pre-installed Android version.
The semi-transparent case has openings for all outputs including the GPIO port making it a great fit projects that are connected to external hardware.
3.5mm male plug to 3 RCA female adapter cable(Red, White, Yellow) connectors for Audio and/or Video devices
The CloudShell-2 for the ODROID-XU4 is an affordable DIY Network Attached Storage (NAS) Solution with RAID support.
This is a perfect connector pack for various DIY projects with the ODROID-C0. You need a soldering skill to use this pack.
Laser Acrylic enclosure for the 3.5 Inch LCD Shield.
DC Plug specification : Inner diameter 0.8mm and outer diameter 2.5mm
Center is positive(RED wire) and outer is negative(BLACK wire)