Raspberry PI Model B ENCLOSURE - White

The connector heads measure 0.51" x 0.36" x 0.25" (13.0 x 9.3 x 6.3 mm) on the USB micro B end and 0.51" x 0.55" x 0.25" (13.0 x 13.8 x 6.3 mm) on the USB A end. 

This cable will let you swap out the stock 150mm long flex cable from a Raspberry Pi Camera (either 'classic' or 'NoIR' type) for a different size. Works great, just carefully open the connector on the Pi and slip this one in. 

The stunning new Raspberry Pi 3 Model B+ has landed at CorpShadow.

This cable will let you swap out the stock 150mm long flex cable from a Raspberry Pi Camera (either 'classic' or 'NoIR' type) for a different size. Works great, just carefully open the connector on the Pi and slip this one in.

Make your Pi a little slimmer with this microSD card adapter board. It slides in where the SD card goes but is half the length. Pop in a microSD card for a sleeker machine. The microSD card holder is a push-push type so you can push on the edge that sticks out to remove the card when necessary. 

Raspberry pi best value power supply which will give you actual 5V after complete boot up. Ideal for general purpose as well, like any device with micro-USB

100% full load burn-in test
Pass LPS
Protections: Short circuit / Overload / Over voltage / Over temperature
Class II power (without earth pin)
2 pole USA plug

It is a good plastic box for Raspberry Pi, which can protect it with one of these snazzy plastic enclosures?. These cases protect the Raspberry Pi from things like rogue wires that might short it out while still allowing full access to the board! Simply snap the RPi into the bottom half of the enclosure, then snap the two sides together. It has windows on four sides for direct access to components.

This is a breadboard, good for small projects. It's 5.5 cm x 16.5 cm with a standard double-strip in the middle and two power rails on both sides.

Deploy your outdoor Raspberry Pi project without concerning rain, snow, dust in this IP65 plastic case with clear top. This weatherproof enclosure has three IP67 SMA to u.FL(IPEX) cable connector for connectivity and a waterproof IP68 micro USB cable-end socket if you want to power your project with modified original Raspberry Pi power supply.

The USB 2.0 Extension Cable extend the distance between your USB peripheral and your USB hub or computer assure good signal quality to meet USB specification.

The board itself is tiny, at around 25mm x 20mm x 9mm. It also weighs just over 3g, making it perfect for mobile or other applications where size and weight are important

TFP401 HDMI/DVI Decoder to 40-Pin TTL Breakout - With Touch

GPIO Header for Raspberry Pi - Extra tall 2x13 Female Header

This pi plate is perfect for when you want to build a stand-alone project with its own user interface. The 4 directional buttons plus select button allows basic control without having to attach a bulky computer.