H4 Mini-ITX Kit

The kit includes:

• The base panel.
• The IO shield-like rear panel plus support panel.
• Necessary standoffs and screws.
• The 24-Pin female ATX PSU starter on/off switch jumper bridge cable plus the red switch (as shown in the photo below.)
• The MOLEX-to-DC Plug cable. Therefore, you can supply power to any of the H4 boards with any ATX PSU (including SFF PSU).

.

Important Note

The ATX PSU brings 12V to the H4 board. If you use SATA hard-disks, SSDs or other devices, power them from the ATX PSU, not from the H4 board. Reason: a H4 board can only correctly power disks when powered itself by a 19V/133W power brick, especially at cold boot time. Meanwhile, even a low level 250+Watt ATX PSU will have no trouble powering a H4 board and all the attached peripherals. If you use a discrete graphics card (with an optional M.2 to PCIe adapter), use a more powerful ATX PSU to cover the power consumption of the graphics card.

The H4 Mini-ITX Kit is designed only for the H4 boards and is not compatible with the H2/H3 boards.

.

.

• Rear side bracket cover
• 4 x 40mm (M/F) PCB Supports (Steel)
• 2 x 32mm (M/F) PCB Supports (Steel)
• 4 x 6mm Truss Head Bolts
• 24-Pin female ATX PSU starter on/off switch jumper bridge cable
• IDE-to-DC Plug cable

.