USB-UART Module Kit
System console interface board for platform development and debugging.
This module kit is easiest way ever to connect to your ODROID serial console port.
CP2104: USB to Serial UART bridge IC with 1.8~3.3V interface
Molex5268-04 connector and cable assembly
Please check the WiKi for more technical information and setup.
- Compatible with
- ODROID-X Series / U Series / XU Series / W / C Series, Raspberry and more
- Cable Type
- USB to Serial UART bridge IC with 1.8V interface
- Board Category
- Return Warranty
- No Returns
- Manufacturer Warranty
- No Returns
16 other products in the same category:
The UPS2 for C1 is designed specifically for the ODROID-C1.
Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut down the ODROID-C1
A single native (non-USB) SATA 3.0 port on the ODROID-M1 is provided for use with a 2.5inch HDD or SSD NAND Memory storage device. This SATA interface delivers near 500MB/s of sequential access. The SATA mount kit contains a SATA Data cable, a SATA Power cable, and a mount plate with some support screws. However, since the SATA power port doesn’t have a 12Volt power rail, a separated external 12Volt SATA power supply is required to use a 3.5inch HDD.