Your cart
There are no more items in your cart
ODROID
US$5.27
Use this USB-DC Power Bridge board with ODROID-XU4 to connect ODROID-VU7 or VU7 Plus
US$59.95
The UPS2 for C1 is designed specifically for the ODROID-C1. Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut...
US$59.95
Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut down the ODROID.
US$2.25
Note: Input voltage should be no more than rated voltage,or the module will be burnt
US$3.80
Part for the I2S 2Watt Stereo Boom Bonnet Kit, for use with the ODROID-XU4 / XU4Q.
US$3.80
Part for the I2S 2Watt Stereo Boom Bonnet Kit, for use with the ODROID C1+ / C2.
US$14.95
System console interface board for platform development and debugging.
US$13.70
A single native (non-USB) SATA 3.0 port on the ODROID-M1 is provided for use with a 2.5inch HDD or SSD NAND Memory storage device. This SATA interface delivers near 500MB/s of sequential access. The SATA mount kit contains a SATA Data cable, a SATA Power cable, and a mount plate with some support screws. However, since the SATA power port doesn’t have a...
US$5.05
SATA cables are perfect for system builds with tight fitting environments with ODROID-H2 Case Type 1, Type 3 and Type 4 to connect a SATA HDD/SSD storage. Utilising compact stackable connectors, this flexible 200mm cables are neat and manageable.
US$4.75
3.5mm male plug to 3 RCA female adapter cable(Red, White, Yellow) connectors for Audio and/or Video devices
US$53.95
SmartPower2 is a power-supply which has WiFi connectivity to control the voltage and switch on/off a connected device.
US$2.43
This is a perfect connector pack for various DIY projects with the ODROID-C0. You need a soldering skill to use this pack.
US$12.95
WIFI Module #5BK uses the same chipset (Realtek RTL8821CU) as WIFI Module #5B, so it is 100% compatible. IEEE 802.11ac/a/b/g/n WLAN and Bluetooth combo module with onboard 2.4Ghz and 5.8Ghz Dual band antenna.
US$14.50
A new and upgraded version of the USB-UART Module Kit featuring a USB-C Port.
US$10.95
This is a breadboard, good for small projects. It's 5.5 cm x 16.5 cm with a standard double-strip in the middle and two power rails on both sides.