Your cart
There are no more items in your cart
ODROID
Active filters
- Board Category: ODROID Cases
- Board Category: ODROID Connectors
- Board Category: ODROID Displays
- Board Category: ODROID Module Reader/Writer
- Board Category: ODROID Mounting kits
- Board Category: ODROID Power Supply
- Board Category: ODROID Storage
- Board Category: ODROID Switches & Battery
- Board Category: Raspberry Pi Boards
- Clear all
US$59.95
The UPS2 for C1 is designed specifically for the ODROID-C1. Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut...
US$8.95
Blue illuminated Power Button with pre-assembled jumper wires.
US$59.95
Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut down the ODROID.
US$4.59
RTC backup battery Lithium primary battery to back up the RTC on XU board. This battery can keep the RTC running up to 5 years without external power supply.
US$8.00
Lithium Polymer rechargeable cell with a protection circuit.
US$15.60
Lithium Polymer rechargeable cell with a protection circuit.
US$2.25
Note: Input voltage should be no more than rated voltage,or the module will be burnt
US$13.70
A single native (non-USB) SATA 3.0 port on the ODROID-M1 is provided for use with a 2.5inch HDD or SSD NAND Memory storage device. This SATA interface delivers near 500MB/s of sequential access. The SATA mount kit contains a SATA Data cable, a SATA Power cable, and a mount plate with some support screws. However, since the SATA power port doesn’t have a...
US$8.95
This LCD displays 20 characters wide, 4 rows in white texts on blue background.
US$53.95
SmartPower2 is a power-supply which has WiFi connectivity to control the voltage and switch on/off a connected device.
US$2.43
This is a perfect connector pack for various DIY projects with the ODROID-C0. You need a soldering skill to use this pack.
US$14.50
A new and upgraded version of the USB-UART Module Kit featuring a USB-C Port.
US$10.95
This is a breadboard, good for small projects. It's 5.5 cm x 16.5 cm with a standard double-strip in the middle and two power rails on both sides.