Your cart
There are no more items in your cart
ODROID
Active filters
- Board Category: ODROID Accessories
- Board Category: ODROID Adapters
- Board Category: ODROID Cables
- Board Category: ODROID Cases
- Board Category: ODROID Connectors
- Board Category: ODROID Expansion Cards
- Board Category: ODROID Module Reader/Writer
- Board Category: ODROID Power Supply
- Board Category: ODROID Storage
- Board Category: ODROID Wireless
- Board Category: Raspberry Pi Boards
- Clear all
US$59.95
The UPS2 for C1 is designed specifically for the ODROID-C1. Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut...
US$59.95
Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut down the ODROID.
US$8.75
Compact Stero Speaker for VU7A Plus and VU5A Plus
US$1.50
The ROM-WT138LM(N) series are remote control receiver modules. Pin diode and receiver IC are assembled on one module. Small- sized, light-weight, and low current consumption. modules have been achieved by using resin mold.
US$5.19
Ultrasonic ranging module HC - SR04 provides 2cm - 400cm non-contact measurement function.
US$3.00
The HC-SR501 Infrared PIR Motion Sensor Module auto-senses light in various applications (in house, basement, outdoor, warehouse, garage, etc,) for ventilator control, alarm, etc. Infrared technology (LHI778 probe design) high sensitivity & high reliability. ultra-low-voltage. widely used especially for battery-powered products. This HC-SR501 Infrared...
US$2.25
Note: Input voltage should be no more than rated voltage,or the module will be burnt
US$1.75
4 channel IIC I2C Logic Level Converter Bi-Directional Module 5V to 3.3V.
US$9.99
This RGB color sensor module is based on the TCS34725 sensor chip made by TAOS. The module is designed by Adafruit who Called it (the best color sensor in the market). This is much confirmed by our own testing and experiments in future Electronics Egypt lab.
US$3.80
Part for the I2S 2Watt Stereo Boom Bonnet Kit, for use with the ODROID-XU4 / XU4Q.
US$3.80
Part for the I2S 2Watt Stereo Boom Bonnet Kit, for use with the ODROID C1+ / C2.
US$8.95
This module is the 16 way GPIO expander for the I2C interface, and built with the MCP23017.MCP23017 has a high-speed I2C interface which supports the I2C frequency of 100KHz, 400KHz and 1.7MHz. The chip has 3 address pins, which can be set up for 8 different addresses. So 8 modules can be connected through two I2C buses to achieve up to 128 IO extensions.
US$14.95
System console interface board for platform development and debugging.
US$5.05
SATA cables are perfect for system builds with tight fitting environments with ODROID-H2 Case Type 1, Type 3 and Type 4 to connect a SATA HDD/SSD storage. Utilising compact stackable connectors, this flexible 200mm cables are neat and manageable.
US$4.75
3.5mm male plug to 3 RCA female adapter cable(Red, White, Yellow) connectors for Audio and/or Video devices
US$19.98
This uses I2S as digital sound standard for audio output. It is super easy. You'll be rockin' out in 15 minutes.
US$4.45
Replacement speaker and joystick assembly for the ODROID-Go Advance system. A direct replacement part for the ones included in the original build of the ODROID Go Advance as shipped.
US$21.65
You're probably itching to make some fun embedded computer projects with ODROID-C2 or ODROID-C1+.
US$53.95
SmartPower2 is a power-supply which has WiFi connectivity to control the voltage and switch on/off a connected device.
US$2.43
This is a perfect connector pack for various DIY projects with the ODROID-C0. You need a soldering skill to use this pack.
US$1.75
5pieces of 10pin male header is excellent choice for your DIY project.
US$14.50
A new and upgraded version of the USB-UART Module Kit featuring a USB-C Port.