U3 IO Shield
U3 IO Shield is the board that can be plugged on the neat of ODROID-U3 via tiny 8 pin IO connector. You can have 36 IO ports of GPIO/PWM/ADC.
The IO Shield board is designed as versatile, general-purpose data acquisition and control module and provides a direct connection to ODROID-U3 IO connector. We added lots of basic but essential goodies. First up, there is a big prototyping area, so you can wire up DIP chips, sensors, and the like. Along the edges of the proto area, all the GPIO/ADC/PWM and power pins are broken out to 0.1" stips so you can easily connect to them. There are also two 3-pin headers for small servo motors connection.
If your ODROID-U3 PCB is rev 0.5, you can access the HW SPI of Exynos-4412 CPU.
We added a SPI Flash memory SST25WF020A on the new U3 IO Shield Rev 0.3.
Finally, we added a 10-pin connector of I2C/GPIO for further expansion.
Refer our Tinkering Kit for your DIY project.
- U3 IO Shield board
- 4 x 20mm PCB spacer (Plastic)
- 4 x 11mm PCB spacer (Metal)
- 4 x 10mm PCB space (Plastic)
* The Metal spacer must be placed between ODROID-U3 and IO Shield board.
1. No Returns
2. One year manufacturers limited warranty
3. All Specifications subject to change without notice.
16 other products in the same category:
The UPS2 for C1 is designed specifically for the ODROID-C1.
Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut down the ODROID-C1