ODROID

HiFi Shield 2
In Stock
Expansion Cards

HiFi Shield 2

ODHIFIS2
US$51.99
The HiFi Shield Plus provides both stereo RCA connectors to connect to external amplifiers and other audio equipment. Via TI’s high-end PCM5242 DAC chip(known as Burr-Brown), it supports 16, 24, 32 bit audio formats with minimal THD+N ratio (0.002%) and ideal dynamics (114dB+), plus amazing sampling rates of 384kHz
U3 IO Shield
In Stock
Expansion Cards

U3 IO Shield

ODU3IOSHLD
US$27.95
U3 IO Shield is the board that can be plugged on the neat of ODROID-U3 via tiny 8 pin IO connector. You can have 36 IO ports of GPIO/PWM/ADC. The shape and dimension are exactly same as ODROID-U3. It comes with 12pcs of PCB spacers for easier and solid stacking assembly.
USB3.0 to SATA Bridge Board Plus
In Stock, Shipping Now
Expansion Cards

USB3.0 to SATA Bridge Board Plus

USB3SATABRP
US$14.98
This board contains a USB3.0 to SATA3 controller (JMicron JMS578) allowing interfacing of a single 2.5" SATA HDD/SDD
RTC Shield for ODROID-C2 RTC Shield for ODROID-C2 2
On Backorder, Available for Order
Power Connectors

RTC Shield for ODROID-C2

ODRTCS
US$6.05
Real Time Clock Shield for the ODROID-C2
ODROID-UPS2 for Odroid C1 ODROID-UPS2 for Odroid C1 2
In Stock
Power Supply

ODROID-UPS2 for Odroid-C1

ODUPSC1
US$59.95
The UPS2 for C1 is designed specifically for the ODROID-C1. Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut...
LED Power Button
In Stock, Shipping Now
Switches & Battery

LED Power Button

ODLPB
US$8.95
Blue illuminated Power Button with pre-assembled jumper wires.
ODROID-UPS3 for Odroid C1 / C1+ / C2. ODROID-UPS3 for Odroid C1 / C1+ / C2. 2
Out of Stock
Power Supply

UPS3 for Odroid C1 / C1+ / C2.

ODUPS3
US$59.95
Uninterrupted Power Supply is an electrical apparatus that provides emergency power to a load when the input power source, typically mains power, fails. The on-battery runtime of most uninterruptible power sources is relatively short but sufficient to start a standby power source or properly shut down the ODROID.
RTC Backup Battery
In Stock
Switches & Battery

RTC Backup Battery

ODRTCB
US$4.59
RTC backup battery Lithium primary battery to back up the RTC on XU board. This battery can keep the RTC running up to 5 years without external power supply. 
750mAh Battery
Limited Stock
Switches & Battery

750mAh Battery

ODBAT750
US$8.00
Lithium Polymer rechargeable cell with a protection circuit.
3000mAh Battery
Out of Stock
Switches & Battery

3000mAh Battery

ODBAT3000
US$15.60
Lithium Polymer rechargeable cell with a protection circuit.
IR Sensor : ROM-WT138L(N)
In Stock
Wireless

IR Sensor : ROM-WT138L(N)

ODIRSEN
US$1.50
The ROM-WT138LM(N) series are remote control receiver modules. Pin diode and receiver IC are assembled on one module. Small- sized, light-weight, and low current consumption. modules have been achieved by using resin mold.
Step up DC-DC
In Stock
Power Supply

Step up DC-DC

ODSUDC
US$2.25
Note: Input voltage should be no more than rated voltage,or the module will be burnt
M1 SATA mount and cable kit
In Stock
Mounting / Adapters

M1 SATA mount and cable kit

ODM1SMKIT
US$13.70
A single native (non-USB) SATA 3.0 port on the ODROID-M1 is provided for use with a 2.5inch HDD or SSD NAND Memory storage device. This SATA interface delivers near 500MB/s of sequential access. The SATA mount kit contains a SATA Data cable, a SATA Power cable, and a mount plate with some support screws. However, since the SATA power port doesn’t have a...
SmartPower2 with 15V/4A PSU
In Stock
Power Supply

SmartPower2 with 15V/4A PSU

ODSMARTPWR2
US$53.95
SmartPower2 is a power-supply which has WiFi connectivity to control the voltage and switch on/off a connected device.
Connector Pack for ODROID-C0
In Stock
Connectors

Connector Pack for ODROID-C0

CPOC0
US$2.43
This is a perfect connector pack for various DIY projects with the ODROID-C0. You need a soldering skill to use this pack.
WiFi Module 5BK WiFi Module 5BK 2
In Stock, Shipping Now
USB Adapters

WiFi Module 5BK

WM5BK
US$12.95
WIFI Module #5BK uses the same chipset (Realtek RTL8821CU) as WIFI Module #5B, so it is 100% compatible. IEEE 802.11ac/a/b/g/n WLAN and Bluetooth combo module with onboard 2.4Ghz and 5.8Ghz Dual band antenna.
USB-UART 2 Module Kit USB-UART 2 Module Kit 2
In Stock, Shipping Now
Connectors

USB-UART 2 Module Kit

ODUA3MT
US$14.50
A new and upgraded version of the USB-UART Module Kit featuring a USB-C Port.
Tiepoint Breadboard
In Stock
Raspberry Pi

Tiepoint Breadboard

CBB1655
US$10.95
This is a breadboard, good for small projects. It's 5.5 cm x 16.5 cm with a standard double-strip in the middle and two power rails on both sides.
Showing 25-45 of 45 item(s)
Product added to wishlist
Product added to compare.

By using this site, you agree to cookies for a better experience. See Privacy Policy.